rmo2010-001-056_a
1. Schrader valve
2. Position the vehicle in front of a test surface as
shown.
rmo2010-001-007_b
A. 10 m (33 ft)
90°
rmo2010-001-008_a
3. Trace 2 lines parallel to the ground on the test
surface as follows:
LINES ON THE TEST SURFACE
Line A
415 mm (16.3 in) above ground
Line B
515 mm (20.3 in) above ground
4. Select
low
beam.
5. Beam aiming is correct when the focus point
(brightest spot) of the headlight reflection is
within the marks.
1
2
A B
rmo2010-001-302_b
TYPICAL HEADLIGHT REFLECTION ON SURFACE TEST
1. Ground
2. Focus point
A. 415 mm (16.3 in) above ground
B. 515 mm (20.3 in) above ground
CE Models (High Beam)
NOTE:
As the low beam and high beam are sep-
arate units, this verification is valid for either left-
hand or right-hand traffic regulations.
1. Follow steps 1 and 2 of the low beam verifica-
tion procedure.
2. Trace 2 lines parallel to the ground on the test
surface as follows:
LINES ON THE TEST SURFACE
Line A
800 mm (31.5 in) above ground
Line B
850 mm (27-1/2 in) above ground
3. Select the
high
beam.
4. Beam aiming is correct when the focus point
(brightest spot) of the headlight reflection is
within the marks.
1
2
A B
rmo2010-001-301_b
TYPICAL HEADLIGHT REFLECTION ON TEST SURFACE
1. Ground
2. Focus point
A. 800 mm (31.5 in) above ground
B. 850 mm (33.5 in) above ground
Headlights Aiming Adjustment
1. Remove both middle side panels.
Upper Headlight Units
2. To adjust headlight beam, turn the adjustment
knob. Adjust both headlights evenly.
SERVICE
2013-2
31 / 47
