rmo2010-001-091_a
1. Brake fluid MAX. level mark
2. Brake fluid MIN. level mark
rmo2010-001-092_a
A. Operating range
6. Immediately wipe up spills if necessary.
7. Prior to installing brake fluid reservoir caps:
– Check that V slit is in good condition.
– Ensure diaphragm are properly positioned.
rbg2008-003-002_a
TYPICAL
1. V slit
vmr2008-033-062_a
TYPICAL
1. Correct position
2. Wrong position
8. Reinstall both caps of the reservoir.
9. Close the seat and ensure it is fully latched.
SETUP
Guidelines
All adjustments have already been performed
at factory. It is only necessary to validate them.
However, if readjustment is needed, refer to the
appropriate
ROADSTER SHOP MANUAL
for the
proper procedure.
Tires Pressure
WARNING
Low pressure may cause tire to deflate and
rotate on wheel. Overpressure may burst the
tire. Always follow recommended pressure.
NOTICE
Always check pressure when tires are
cold before using the vehicle.
NOTE:
Tire pressure changes with temperature
and altitude. Recheck pressure if one of these
conditions has changed (e.g., significant weather
change, driving in the mountains).
1. Inflate tires to the specified air pressure. Refer
to the following table.
COLD TIRE PRESSURE RECOMMENDATION
FRONT
REAR
103 kPa ± 14 kPa
(15 PSI ± 2 PSI)
193 kPa ± 14 kPa
(28 PSI ± 2 PSI)
NOTE:
The pressure difference between the left
and right side tire should not exceed 3.4 kPa
(.5 PSI).
For your convenience, an electronic pressure
gauge is supplied in the tool kit.
SERVICE
2013-2
27 / 47
