6-36
Precautions to keep good printing quality/use printer over the long term
(16)
Remove the cap you connected in step (6) from the tube, and connect the tubes to the print head.
<IMPORTANT>
Check the stamp on the print head and the tube number, and make sure that they are connected in the correct position.
Incorrectly connecting them may cause the ink to leak during the circulation.
<CAUTION>
Ensure that the flat cables do not extend past the edge of the cover.
(17)
Tighten the nut firmly until it stops so that each tube is fixed to the print head.
Head A side
1
2
3
4
Head B side
5
6
7
8
(18)
Close the upper left-hand-side cover and top cover and turn on the power.
(19)
From the menu, select [Maintenance] > [Install Ink after Replacing Head] > [Corresponding print head], and press
.
Perform the work operation by following the on-screen instructions.
<TIPS>
After the procedures are completed, the current screen will go back to the standby mode screen.
Replace other print heads in the same way.
(20)
Print the nozzle check patterns.
☞
"6-1-17. Print out the nozzle check pattern (checking on the print heads)
>>P.6-44"
(21)
Perform the initial settings after head replacement configuration.
☞
"3-6-1. Initial settings after head replacement
>>P.3-24"
(22)
After color head replacement, if any, make color adjustment for 2 color heads.
☞
"3-6-2. Color adjustments
between the two color heads >> P.3-25"
(23)
Adjust the ejection timing of the print head.
☞
"3-6-3. Firing adjustment >>P.3-26"
(24)
Make position adjustments for the 2 heads of the same color.
☞
"3-6-4. 2 same color heads position adjustment
>>P.3-27"
(25)
Perform the platen feed adjustment.
☞
"3-6-5. Platen-rolling adjustment >>P.3-28"
(26)
Make the position adjustment between the white head and the color head.
☞
"3-6-6. White/color alignment
>>P.3-29"
1 2
3 4
5 6
7 8
X1009
*Remove the ink clot.
Tube
Nut
Print head
