8 - 3
R E M O T E F A X O P T I O N S ( F O R F A X - 6 4 5 O N L Y )
Remote Commands
Follow the commands below to access features remotely. When you call the FAX/
MFC and enter your Remote Retrieval Access Code (1 5 9
), the system will signal
you with two short beeps to enter a remote command.
Remote Commands
Operation Details
95 Changing Fax
Forwarding setting
1 OFF
If you hear one long beep, the change is accepted. If
you hear three short beeps, you cannot change it
because the conditions have not been met (Example:
registering fax forwarding). You can register your
fax forwarding number by using 4. FAX FWD NO
(see p. 8-1). Once you have registered the number,
the FAX/MFC will change automatically to
FAXFWD:ON mode. Then retrieve a Memory
Status List by entering 961 (see p. 8-4) to make sure
that the Fax Forwarding number you registered is
correct in the List.
2 Fax Forwarding
4 FAX FWD No.
6 Fax Storage ON
You can set FAX STORAGE to ON or OFF.
7 Fax Storage OFF
96 Retrieve a fax
1 Memory Status List
Enter the number of a remote FAX/MFC to receive
the Memory Status List or stored fax message(s).
(See p. 8-4)
2 Retrieve all faxes
3 Erase fax from the
memory
If you hear one long beep, you can erase fax
message(s) from the memory.
97 Check the Receiving
Status
You can check whether your FAX/MFC has
received any faxes. If yes, you will hear one long
beep. If no, you will hear three short beeps.
1 FAX
98 Change Receive Mode If you hear one long beep, you can change the
Receive Mode. If you hear three short beeps, you
cannot change it.
1 TAD
2 F/T
3 FAX
90 Exit
After a long beep, you can exit remote access.
