Brocade Communications Systems FastIron SX 1600, Configuration Manual, Page: 441 / 593

TABLE 94 show ip bgp summary output descriptions (continued)
This field Displays
• If soft reconfiguration is not enabled, this field shows the
number of BGP4 routes that have been filtered out.
Sent The number of BGP4 routes the device has sent to the neighbor.
ToSend The number of routes the device has queued to advertise and withdraw to
a neighbor.
Displaying the active BGP4 configuration
To view the active BGP4 configuration information contained in the running configuration without displaying the entire running
configuration, enter the following command at any level of the CLI.
device# show ip bgp config
router bgp
local-as 200
neighbor 10.102.1.1 remote-as 200
neighbor 10.102.1.1 ebgp-multihop
neighbor 10.102.1.1 update-source loopback 1
neighbor 192.168.2.1 remote-as 100
neighbor 10.200.2.2 remote-as 400
neighbor 2001:db8::1:1 remote-as 200
neighbor 2001:db8::1:2 remote-as 400
neighbor 2001:db8::1 remote-as 300
address-family ipv4 unicast
no neighbor 2001:db8::1:1 activate
no neighbor 2001:db8::1:2 activate
no neighbor 2001:db8::1 activate
exit-address-family
address-family ipv6 unicast
redistribute static
neighbor 2001:db8::1:1 activate
neighbor 2001:db8::1:2 activate
neighbor 2001:db8::1 activate
exit-address-family
end of BGP configuration
Syntax: show ip bgp config
Displaying summary neighbor information
The show ip bgp neighbor command output has the following limitations.
1. If BGP4 peer is not configured for an address-family, the peer information will NOT be displayed.
Displaying BGP4 information
FastIron Ethernet Switch Layer 3 Routing
53-1003627-04 441