Brocade Communications Systems Fabric OS v7.0.1, Command Reference Manual

Page: 225 / 1132

Fabric OS Command Reference 199
53-1001764-01
cryptoCfg
2
--manual_rekey
Performs a manual rekeying of a specified LUN associated with a specified CTC.
Manual rekeying is performed in both online and offline fashion depending on
whether or not the host is online or host I/O is present. If any policy-based
rekeying operation is currently in progress, this command aborts with a warning
message. This command is valid only on the group leader.
The following operands are supported:
crypto_target_container_name
Specifies the name of the CTC to which this LUN belongs.
LUN_Num
Specifies the number of the LUN to be rekeyed. Use the --show -container
command for a list of LUN numbers associated with the specified CTC.
initiator_PWWN
Specifies the port WWN of the initiator for the specified LUN.
-include_mirror
Initiates a manual rekey on mirror LUN or on a primary LUN in read-only state.
This operand is required if the specified LUN is mirror LUN or a primary that has
been restored from an out-of-sync mirror LUN.
-all
Performs a manual rekey operation on all encrypted primary or nonreplicated
LUNs on the node that are in read-write state. This operation may take an
extended period of time.
-include_mirror
Initiates a manual rekey operation on all primary LUNs and mirror LUNs in
read-only state. In addition, this command also starts a manual rekey operation on
all primary and nonreplicated LUNs in read-write state.
--resume_rekey
Resumes a suspended rekey session for a specified disk LUN at the termination
point. A rekey session may terminate prematurely due to unrecoverable medium
or hardware errors. When a rekey session terminates prematurely, the system
logs CRITICAL RASlog and rekey operation failure status messages. You must
take corrective action to clear all error conditions that caused the rekey failure
before resuming a suspended rekey session. All DEK or HA cluster members
must be online and reachable for this operation to succeed.
crypto_target_container_name
Specifies the name of the CTC to which the LUN belongs.
LUN_Num
Specifies the number of the LUN to be rekeyed. Use the --show -container
command for a list of LUN numbers associated with the specified CTC.
initiator_PWWN
Specifies the initiator port WWN for the specified LUN.
--discoverLUN
Performs LUN discovery. This command discovers and displays all LUNs that are
discoverable by the initiators of a specified CTC. This command is valid only on
the node that hosts the CTC. The following operand is required:
crypto_target_container_name
Specifies the name of the CTC.