Brocade Communications Systems Fabric OS v7.0.1, Command Reference Manual

Page: 1044 / 1132

1018 Fabric OS Command Reference
53-1001764-01
thConfig
22
NOTES
Monitoring of Condor 3-based 10G SFPs, 16G SFPs, and 16G QSFPs (quad small form-factor
pluggables) is by default disabled. Use the
thMonitor command to enable monitoring of these advanced
SFPs.
The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may be in
place. Refer to Chapter 1, "Using Fabric OS Commands" and Appendix A, "Command Availability" for
details.
The Fabric and Security classes are not supported in Access Gateway mode.
OPERANDS
This command has the following operands:
class
Specifies a Fabric Watch class to be monitored. This operand is optional with the
--show option and required with all configuration options.
-area area
Specifies the area that can be configured for a specified class. This operand is
optional with the
--show option and required with all configuration options. Areas
are specific to each class. The following classes and associated areas are
configurable with the
thConfig command. Classes and areas are not case
sensitive.
SFP
Monitors the SFP class. When used with the -sfptype option on Condor 3-based
platforms, thresholds configured for the SFP class apply to 16G SFPs, 10G SFPs,
and 16G QSFPs. Valid areas for the SFP class include the following:
TEMP
Monitors the physical temperature of the SFP in degrees Celsius. For 16G
QSFPs, Fabric Watch monitors temperature only on the first QSFP port that
is available on the (logical) switch.
RXP
Measures Receive Power for the SPF in Watts.
TXP
Measures Transmit Power for the SPF in Watts (not supported on 16G
QSFPs).
CURRENT
Measures the amount of current supplied to the SFP transceiver.
VOLTAGE
Measures the amount of voltage supplied to the SFP. For 16G QSFPs, Fabric
Watch monitors voltage only on the first QSFP port that is available on the
(logical) switch.
ST
Measures the number of SFP state changes This area is deprecated as of
Fabric OS v7.0. To configure SFP State Changes, use the
fwFruCfg
command.
PWRONHRS
Measures the number of operational hours (power-on hours) for the SFP.
This class is supported only for 16G SFPs and QSFPs (Condor 3 ASIC), and
the only valid time base for this class is
none . You can display the power-on
hours with the sfpShow command.
FABRIC
Monitors the Fabric class. Valid areas for the Fabric class include the following:
ED
Tracks the number of times an E_Port or VE_Port goes down.