Brave Smyle - C, User Manual

Page: 27 / 58

BRAVE
– user guide
27
4.2 PC programming
– BraveSet programm
For PC programming of door intercom you have to purchase special
USB cable USB-KAB and programm BraveSet ( free on every CD). Then you
have to connect door intercom into the line or at version
/C or (C) switched ON
and connected power supply 12V - DIP3 and 4.
Procedure:
-
Connect telephone line into door intercom or at version /C and (C) you can
use external power supply 12V (DIP 3,4)
- Connect special USB cable to PC USB socket . Door interocm picks up the
line within 3 seconds and play tone of programming enter (via. capture
capture 3.1 page.21).
- Run programm BraveSet. Door intercom is in programming mode during all
the time when programm BraveSet is running. The door intercom stays
pasive until moment of USB cable disconnection. When you loose
connection please disconnect USB cable from door intercom and connect it
again
– door intercom picks up.
- Correct connection PC with BraveSet programm is indicated by reading
firmware version from door intercom ( visible in bar) as same as reading the
time ( shown in left top corner). When you have version
(LC) then time is 0
because LC version doesnt includes RTC circuit.
For easy orientation are parametres in BraveSet programm marked by
the same codes like codes for programming by phone.
Details about setting you will find in programm HELP and on website
www.alphatech.cz .
USB cable is special cable with galvanical isolation and with 3V
convertor. The galvanical isolation is neccessary because telephone line must
not be grounded and PC´s are usually grounded.