BRAILLO
l
B 650 SW2.1
103
5.18
Main sensor wheel - adjustment
The main sensor wheel is placed on the lower shaft, on the opposite end from the belt.
The shafts must be in the position indicated to the left in the figure below.
The timing wheel should now be placed exactly like position (A) in the figure below, i.e. the mark in
the middle of the opening in the wheel is placed just opposite the sensor.
If the timing wheel is not in it’s correct position, it must be adjusted.
Keep the shafts in this position while loosen the screws (B) holding the timing wheel. Turn the tim
-
ing wheel until the inductive sensor is placed just opposite the mark in the middle of the opening in
wheel. Then fasten the screws again.
Keep the shafts in
this position
Sensor
The notch must be in the
middle of the sensor
B
A
