Braillo 600 SR, User Manual

Page: 113 / 119

BRAILLO
l
B 600 SR
113
8.4 Service and maintenance
Troubleshooting Paper Roll Feeder
The Paper Roll Feeder may be considered as an independent unit, even though it is switched on and
off with the main switch on the Printer.
If the Paper Roll Feeder motor does not start, please check the following:
Is the green power lamp illuminated ?
If no; Is the main switch on the Printer turned on ?
Is the Paper Roll Feeder connected to the Printer ?
Is the Emergency Switch pressed down ?
If yes; Is the mains cable to the Paper Roll Feeder connected to an outlet with power ?
Is the paper positioned nearby the floor, so it is actually in correct position ?
Do also note that if the laser distance sensor is not finding anything between 20 cm and 80
cm from the sensors front, the motor will not start. Try to hold a piece of paper in front of the
sensor, approx. 30 - 40 cm away. Now the motor should start.
If the motor starts, but the paper is not moving, check the press air supply. The paper Roll Feeder
requires press air to function.
Maintenance Paper Roll Feeder
The Paper Roll Feeder will not need much maintenance. The bearings are of a sealed type and will
not need any lubrication.
The most important thing is to ensure that the rolls are clean and undamaged. Keep especially an eye on
the rubber roll. The rolls may be cleaned with a cloth moisturized with alcohol.