Braillo 600 SR, User Manual

Page: 54 / 119

4.3 Magnet rack, removal
Please see figures below:
Magnet racks A and C (the two on the side
where the paper goes into the printer) are quite
easy to reach, but to remove magnet rack B
and D, it is often best to first remove the paper
cutter and the paper feeder (see figure down to
the right).
Disconnect the cables for the magnet rack.
Make sure that the brass eccentrics at the ends
of the magnet rack is touching the magnet rack
on both ends. This to be able to get it back to
the exact same position sideways.
Remove the magnet rack by unscrewing the
four screws shown in the figure.
Position plate
Note!
Before removing the cutter, make sure that the posi-
tion on the cutter can be re-established. This is done by fixing
the position plates at the back edge of the cutter. This has to
be done at both sides.
Paper cutter
Paper
feeder
BRAILLO
l
B 600 SR
54