4.18 Inductive sensors - adjustment
This printer uses inductive sensors in three places. One for the main timing wheel on the lower shaft,
and two are controlling the movement on the paper feed mechanism.
It is possible to check if the inductive sensors are functioning by looking at the rear end where the
cable enters the sensor. Inside the sensor is a little LED lamp that will be lit if a magnetic object is in
front of the sensor. The light comes out through some transparent plastic around the cable.
So by having the power turned on, and at the same time turning the shafts, the light should go on
and off.
When replacing/adjusting the sensors, the gap between the timing wheel and the sensors can be
maximum 0.6 mm. See figure below.
BRAILLO
l
NORWAY AS
B 300 S2
68
m„¯N ’„¢ PNVžž
iŸ‹ªŠ¨”«Ž
§ŽŸ§¡¥
t”ž”Ÿ’ “ŽŽ›
Summary of Contents for 300 S2
