4.15 Main sensor wheel - adjustment
The main sensor wheel is placed on the lower shaft, on the opposite end from the belt.
The shafts must be in the position indicated to the left in the figure below.
The timing wheel should now be placed exactly like position (A) in the figure below, i.e. the mark in
the middle of the opening in the wheel is placed just opposite the sensor.
If the timing wheel is not in it’s correct position, it must be adjusted.
Keep the shafts in this position while loosen screw (B) holding the timing wheel. Turn the timing
wheel until the inductive sensor is placed just opposite the mark in the middle of the opening in wheel.
Then fasten the screw again.
A
B
BRAILLO
l
NORWAY AS
B 300 S2
65
Summary of Contents for 300 S2
