4. INSTALLING CHILD SEAT. GROUP 1.
Only suitable for Group 1, approx.
9 months to 4 years (9-18 Kg.)
WARNING
Installing the child seat forward facing can only be maid if the child is
more than 9 kg.
1.
Recline the seat using handle
N
placing the back in position 2, 3 or 4
(it is advisable to choose an angle before installing the seat, because
to change it later it is necessary to readjust the harnesses again) (4.1).
2.
Open the harness system by pressing
H
the red button on the child
seat buckle (4.2).
3.
Remove the inner cushion but keep it handy to later put in place (4.3).
4.
Place the child seat on the vehicle seat facing forwards (4.4).
7.
For greater space and to loosen the harness, it is necessary to press
L
harness adjustment button, while simultaneously pulling the harness
straps towards you with your other hand (do not pull the harness
protector) (3.8).
8.
Put inner cushion once more in place for Group 0 + and make sure the
vehicle’s safety belt is taut and not twisted (3.9).
9.
Place the child in the child restraint seat making sure he is not sitting
on the harness or buckle protector. (3:10).
10.
Join buckles in buckle-holder; insert both buckles in child seat buckle-
holder. You should hear a “
click
” when it has been properly secured
(4:11).
11.
Pull harness adjuster
M
to snugly adjust harnesses, harness straps
should lie comfortably on the child, without too much slack. It should
lie gently on the child without exerting pressure or causing damage
and the child should not be obliged to assume a bad posture (3:12).
Always check that the harness straps are suitable for the height of your
child. The shoulders of the child should always be just below the back
slots at a suitable height (3.13).
IMPORTANT
5.
Insert the waist safety belt through the
F
seat belt guides, pass the
diagonal shoulder belt behind the child seat, insert the seat belt in
the vehicle anchor point and press until you hear a “
click
” so that
the child seat is properly installed (4.5).
6.
Pass the diagonal shoulder belt through guide
D
on the side of the
anchor point and through guide
B
and round the seat belt on the
opposite side to the vehicle anchor point, making sure the waist
seat belt that passes through
F
guides is taut and not twisted (4.6,
4.7, 4.8 and 4.9).
7.
Put inner cushion once more in place for Group 0 + and make sure
the vehicle’s safety belt is taut and not twisted (4.10).
8.
For greater space and to loosen the harness, it is necessary to
press
L
harness adjustment button, while simultaneously pulling the
harness straps towards you with your other hand (do not pull the
harness protector) (4.11).
9.
Place the child in the child restraint seat making sure he is not
sitting on the harness or buckle protector. (4.12).
10.
Join buckles in buckle-holder; insert both buckles in child seat
buckle-holder. You should hear a “
click
” when it has been properly
secured (4.13).
11.
Pull harness adjuster
M
to snugly adjust harnesses, harness straps
should lie comfortably on the child, without too much slack. It
should lie gently on the child without exerting pressure or causing
damage and the child should not be obliged to assume a bad
posture (4.14).
Always check that the harness straps are suitable for the height of your
child. The shoulders of the child should always be just below the back
slots at a suitable height (4.15).
24
25
www.babyqs.com
BT012
Child restraint system
Group 0+/1/2
EN
