BOXER KING 5600, Service Manual

Page: 127 / 140

Service Manual 04/2010 Rev.B
127
Fig.307
Stop to push the seal in when the wood has
reached the support.
Mount the support again following 7.20
without perform any worm screw adjustment.
Check if the machine works fine.
7.22 CHUCK SEAL: CHECK AND
REPLACEMENT
: 6h
: End wrenches 13,17,19,22mm, socket
wrench 22 and 24mm, 13mm tube type
wrench, 4,10 and 12mm Allen wrenches,
rubber hammer, silicon, loctite, glue.
L
: The defective worm screw seal may cause
the following inconvenience:
1. Gear oil leaking from chuck cylinder rear
flange.
TO CHECK THE SEAL:
Turn on the machine.
If the chuck cylinder rear flange shows oil
leaking during the rotation, the seal is
defective and it must be replaced.
IMPORTANT:
BEFORE STARTING WITH ANY OPERATION
VERIFY IF THE CHUCK CYLINDER HAS AXIAL
PLAY BECAUSE IN THIS CASE THE PROBLEM
CAN BE SOLVED BY INSERTING ONE OR
MORE SHIMS BETWEEN FLANGE AND
CYLINDER.
ALSO VERIFY IF THE HYDRAULIC OIL LEVEL
IS FINE JUST TO BE SURE THAT THE OIL IS
GETTING OUT IS REALLY FROM THE GEAR.
TO REPLACE THE SEAL:
Remove the gear oil
Remove the safety lever 5.19.
Remove the worm screw assy 7.20.
Remove the bigger tank.
Remove the rear cylinder flange 6.14.
Remove the chuck from the arm (Fig.308) by
using a fork lift.
Fig.308
Replace the chuck seal by locking the new
one with silicon in the back side (Fig.309).
Fig.309
Mount the chuck without forget to install the
shim.
Mount the rear cylinder flange 6.14.
Mount the big tank by placing the silicon as
shown in Fig.310
Fig.310