Boston Whaler 420 OUTRAGE, Owner'S Manual

Page: 59 / 268

2-11 420 Outrage
Chapter 2 • General Information
R
NOTICE
• The deck drain provides self-bailing capabilities while the boat is static in the water and
no passengers on board. This feature prevents the accumulation of water in the cockpit.
The drain plug must be in place when underway.
• Depending on the type of boat you have, you may have underwater fittings that need drain
plugs. Garboard drain plugs and fishbox drain plugs need to be in place before the boat
goes into the water. Any fitting that will be underwater needs to be plugged or the seacock
needs to be closed.
• Through hull fittings and deck drain scupper flaps should be checked for proper seal annually. When
the boat is in the water the underwater fittings can be checked for dripping. It is recommended
that the underwater fittings be removed, cleaned and resealed every other year.
• If the through hull fittings need to be replaced, it is recommended that an authorized Boston
Whaler dealer perform this type of repair. Through hull fittings that are improperly installed
can cause premature hull failure and may void the Boston Whaler limited warranty.
Thru-Hull Fittings, Bilge
Figure 2.11.1
1
2
3
RAW WATER INTAKE/AFT LIVEWELL INLET
LEANING POST LIVEWELL INTAKE
WASTE SYSTEM DISCHARGE
GENERATOR INTAKE
A/C SYSTEM AND FREEZER PLATE INTAKE
ELECTRONIC TRANSDUCER (OPTION)
ELECTRONIC TRANSDUCER
GYROSCOPIC STABILIZER INTAKE (OPTION)
4
5
FWD
• A standard 1” Snap-Tite plug can be used to replace the garboard drain plug in your boat.
It is recommended that you carry spare plugs to be used in the event that the garboard drain
plug becomes lost or damaged.
1
2
3
4
6
5
6
7
7
8
8