Boston Whaler 420 OUTRAGE, Owner'S Manual

Page: 252 / 268

5-6
Chapter 5 • Care & Maintenance
R
420 Outrage
Canvas
To keep your canvas and metal parts in good working
condition and in good appearance, you will need to
keep them clean.
The fabric should be cleaned regularly before
substances such as dirt, pollen, etc. are allowed to
accumulate on and become embedded in the fabric.
The canvas can be cleaned without being removed
from the installation.
Chafing, fiber wear from dirt and grit and deterioration
from ultraviolet light can cause your canvas to
degrade over time.
NOTICE
Do not use detergents, bleach or solvents to
clean your canvas.
Instrument Gauges
When gauges are exposed to a saltwater environment,
salt crystals may form on the bezel and plastic covers.
Remove the salt crystals with a soft damp cloth.
Clean with a mild household detergent or plastic
cleaner.
Never use abrasives or rough, dirty cloths to clean
plastic parts. A mild household detergent or plastic
cleaner should be used. Wipe clean with a damp
chamois.
FOR MORE INFORMATION, CONTACT MERCURY MARINE
CUSTOMER SERVICE AT 920-929-5040
The vinyl material and superior finish has been
tested to resist heavy abrasion. Complete cleaning
instructions are included in the owner’s packet. Read
all information provided by the cushion manufacturer
regarding the proper cleaning and maintenance.
Your cushions are not waterproof. They are
constructed of open-cell foam and will absorb and
hold water. The foam is wrapped with a plastic barrier
Cushions
Saltwater, salt residue, dirt, ultra-violet rays etc. will
take their toll on vinyl products causing them to lose
their luster and texture.
The cushions on your boat are made of a durable
vinyl material called OMNOVA which is protected
by a finish called PreFixx. PreFixx will keep your
cushions looking new far longer than most other
vinyl upholstery.
To Clean Cushions
Solvents are flammable. Exercise proper care.
Wear rubber gloves during all cleaning activity.
Use caution when cleaning around buttons,
stitching and wood or decorative trim; solvents
could seriously damage such areas.
!
CAUTION
• Remove ordinary dirt and smudges with a mild
soap and water solution. Dry with a soft, lint-
free cloth or towel.
• More difficult stains can be cleaned using
rubbing alcohol (isopropyl alcohol). Rinse
cleaned area with freshwater and dry with a
clean, soft, lint-free cloth or towel.
• Seemingly permanent stains like ballpoint ink
can be cleaned with active solvents such as
nail polish remover when applied with a soft
cloth or damp sponge and rubbed. Rinse
cleaned area with freshwater and dry
with a clean, soft, lint-free cloth or towel.
Whenever electrical or electronic changes are made
to the boat, a qualified marine technician should
check aluminum parts for stray currents. Make sure
all electronic equipment is properly grounded with
adequate sized wire.
which helps to keep water from being absorbed into
the foam but also will not allow water to dissipate
once the foam is soaked. Do not leave the cushions in
standing water or exposed to heavy, prolonged rain.
If, in the event your cushions become waterlogged,
remove the foam from the cushion, press as much
water as you can from the foam and allow to air dry.
Make sure the plastic wrap is dry before wrapping
the foam and inserting it back into the cushion.
To prevent mildew, keep the vinyl dry and make
sure that moisture does not accumulate between the
cushions.