Boston Whaler 420 OUTRAGE, Owner'S Manual

Page: 250 / 268

5-4
Chapter 5 • Care & Maintenance
R
420 Outrage
Rubrails
The rubrail on your boat is constructed of an injected
high density PVC vinyl material which laboratory
tests have proven to be highly resistant to staining,
fading and cracking.
As resilient as this material is, you still need to follow
some basic maintenance precautions.
General maintenance requires a thorough cleaning
with mild soap and water. Do not use any cleaning
agents which contain chemicals.
Although the outer shell is tough and durable, there
is a chance that it can be breached. Use care when
docking or exposing the rubrail to conditions which
may cause damage such as docking against heavily
barnacle-encrusted pilings.
Some tears (cleanly sliced) can be repaired with a
super glue type product.
Fiberglass and Non-Skid
To protect your deck and non-skid areas from the
deteriorating affects of the sun, oxidation, water
spots and pollution, use a good quality “fiberglass
and non-skid deck” wax every two to three months.
When applied to your deck and non-skid areas, as
recommended by the manufacturer, the wax forms a
protective non-slick surface which will keep debris
from sticking. Dirt, soot, bird droppings, and even
fish blood will rinse right off.
The cleaner your stainless trim and fittings can be
kept, the greater the assurance of optimum corrosion
resistance. Without proper care even the best stainless
steel will corrode.
Stainless steel is strong and corrosion resistant, but
still requires maintenance to keep its appearance.
Frequent routine cleaning of stainless steel with a
mild soap and water solution and coating with a good
grade cleaning wax will help maintain the finish.
• Wash with mild soap and cold or
lukewarm water.
• Dry thoroughly.
• Apply cleaning wax with a soft, dry cloth.
• Allow wax to dry, then polish and buff.
Stainless Steel
NOTICE
Masking tape is not recommended for the types
of paint you will be using.
NOTICE
Never use abrasive cleaners, detergents or soft
scrub type cleaners to wash your boats surfaces.
Never use abrasive pads, brushes or sponges to
attempt to remove stubborn stains.
Never use strong solvents or detergents which
contain chlorine.
Follow the paint manufacturer’s recommendation for
applying the paint. Humidity and weather will play
a role in how and when the paint is applied. Several
thin layers are better than one thick layer.
To determine the waterline, you will need to place the
boat in water with a full load of fuel and gear. Mark
the waterline and measure above the marked line
1 to 3 inches for placement of the tape line.
Make sure that there is enough paint left to cover
areas that were not accessible, (slings, jack stands
etc.) and paint accordingly. Follow the paint
manufacturer’s recommendation for do’s and don’ts
after the painting is complete.
NOTICE
Painting your boat’s hull will adversely affect
the boat’s speed and performance and may
require re-propping if the maximum engine
RPMs drop below the engine model/mfg
recommended operating range.
Thoroughly clean and dry the affected area. Apply
glue and hold the surfaces together. Areas which have
been torn or are affected by heavy abrasion will have
to have the damaged section replaced. Please see
your Boston Whaler
®
dealer for this type of repair.
Even the finest cleaning powders can scratch or
burnish a mill-rolled surface. On polished finishes,