Boston Whaler 420 OUTRAGE, Owner'S Manual

Page: 142 / 268

3-48 420 Outrage
Chapter 3 • Systems Overview & Operation
R
Operation
NOTICE
Before operating the windlass be sure that the
safety lanyard is removed from the anchor and
is clear of the rode as it pays out or is retrieved.
NOTICE
ALWAYS SECURE THE LANYARD
WHEN UNDERWAY
Failure to do so may allow accidental deployment
of the anchor.
Use the anchor windlass switch on the helm
when possible. Use care when operating the
anchor windlass with the hand-held remote.
!
DANGER
Operating From the Helm
LOWERING
- Pushing the top part of the switch
down will power the anchor windlass DOWN. Make
certain that the safety lanyard is detached from the
chain and is clear of any moving parts of the anchor
windlass.
RAISING - Pushing the lower part of the switch will
power the anchor windlass UP. Once the anchor and
rode is secure in the UP position, the safety lanyard
can be re-attached to the anchor and secured to the
cleat.
Operating From the Bow
The anchor windlass can be operated from the bow
with the use of the windlass remote which is stowed
in the bow locker.
Windlass Remote
Fig. 3.48.1
HAND HELD REMOTE
POWER SOURCE
EXPANDABLE WASHDOWN HOSE
3
2
1
3
2
1
Keep hands, feet, hair and loose clothing clear
of moving parts. Entanglement may cause
severe bodily injury (i.e. lose of fingers or
toes).
!
WARNING
Anchor Windlass Remote
Fig. 3.48.2
1
2
3
WINDLASS REMOTE CONTROL
“DOWN” BUTTON
“UP” BUTTON
1
UP
DO
WN
2
3
The windlass remote control is protected by a 10 amp
reset breaker located on the 12V DC breaker panel on
the port side of the cabin. If there is a loss of power
to the windlass remote, check the “WINDLASS
CONTROL” breaker. If the breaker is tripped, reset
the breaker.