AutoDome Modular Camera System
Configuring and Using the IP AutoDome | en
49
Bosch Security Systems, Inc.
VG4-200, VG4-300, VG4-500i Series User’s Manual
F01U073308 | 1.0 | 2007.09
To View a Preset Shot:
1.
Click the number of the scene you want to view using the on-screen keypad.
2.
Click the
Show Shot
button.
8.8
Alarm Connections
The Alarm Connections screen allows users to specify up to ten IP addresses which the device
attempts to establish a connection with in the event of an alarm. The device contacts the first
specified IP address and then each subsequent address until the device establishes a
connection.
Figure 8.10
Alarm Connections
To connect an alarm, do the following:
1.
Open the IP AutoDome
Livepage
, then click the
Settings
tab.
2.
Click the
Alarm Settings
link, then click
Alarm Connections
. The IP AutoDome displays
the
Alarm Connections
screen (see
Figure 8.10
).
3.
Click the
Connect on Alarm
drop-down list and select
On
to establish a connection to a
pre-defined IP address in the event of an alarm.
Off
, indicates no alarm connections are
made and
Follows Input x
, triggers an alarm.
4.
Click the
Number of destination IP address
drop-down list and select a number from one
to ten to specify the number of the IP addresses. To configure multiple IP addresses,
select a number for the destination IP address, configure the settings described below
and then click the
Set
button. You must click the
Set
button prior to configuring the
settings for another IP address.
5.
Click inside the
Destination IP address
input box and type an IP address.
6.
Click inside the
Destination password
input box and type the appropriate password for
the IP address, if required.
7.
Click the
Video transmission
pull-down list and make a selection.
8.
Click the
Remote port
pull-down list and make a selection. Depending on the network
configuration, select a browser port here. The ports for HTTPS connections will be
available only if the
On
option is selected for the
SSL encryption
parameter.
9.
Click the
Monitor
pull-down list and make a selection from one to four.
10. Click the
Coder
pull-down list and make a selection from one to four.
i
NOTICE!
For more information about the IP AutoDome settings and controls, click the
Help on
this page?
link to open the IP AutoDome online help.
