26
en | Pelco® Protocol Mode
AutoDome Modular Camera System
F01U073308 | 3.0 | 2007.09
VG4-200, VG4-300, VG4-500i Series User’s Manual
Bosch Security Systems, Inc.
4.3
Pelco Keyboard Commands
Pelco control commands are composed of a sequence of two (2) keyboard inputs with the
following convention: 1) a
Command Number
and 2) a
Function
key input.
The AutoDome uses the
PRESET
command key to save and recall presets (pre-positions) 1
through 99.
4.3.1
Special Preset Commands
Some
Pelco
mode preset commands have a special meaning and override the normal Pelco
preset function as follows:
i
NOTICE!
To save a preset, enter the desired number and hold the
PRESET
key for
approximately two (2) seconds. To recall a preset, enter the desired preset number (or
command) and momentarily press and release the
PRESET
key.
Preset Command Description
33-PRESET
Pans the AutoDome 180° (Flip).
34-PRESET
Goes to
Zero Pan
(original home position).
92-PRESET
Sets the
Left
pan limit for an AutoScan with
Limit Stops
enabled.
93-PRESET
Sets the
Right
pan limit for an AutoScan with
Limit Stops
enabled.
94-PRESET
Initiates a
Preset Tour
.
95-PRESET
Enables or disables
Limit Stops
in the
Setup Menu
for AutoScan.
Invokes the Pelco main
Setup Menu
when pressed for 2 seconds.
96-PRESET
Stops a scan.
97-PRESET
Initiates FastAddress (Pelco Random Scan).
98-PRESET
Toggles the
Synch. Mode
between
Line Lock
and
Internal
(Pelco Frame
Scan). This command is available only for two (2) minutes after the
power is applied and then reverts to normal preset functionality.
99-PRESET
Starts an AutoScan
i
NOTICE!
Some Pelco controllers do not support all the preset command numbers. Consult
the specific Pelco controller's documentation for supported preset commands.
