Wiring the Device
Figure 5.4: Preparing the Cables for Wiring
1.
Cut the cables to approximately 152.4 mm (6 in.) (see the figure Preparing the Cables for
Wiring, above). The earth cable must be longer than the power wires by approximately 10
mm or more to prevent disconnection.
2.
Cover the power cable with the plastic tube supplied. Fix it with the tie thread.
3.
Make a group with all signal cables and fix them with the tie thread. See the illustration
below for a proper cable connection.
Note: IR360 version boards will vary slightly because the signals connector has 16 lines as
instead of 19, as shown below.
5.2
24
en | Installing the High Speed Positioning System
High-Speed Positioning System
(HSPS)
2013.11 | 5.2 | F.01U.291.981
Operation Manual
Bosch Security Systems, Inc.
Summary of Contents for UPH Series
Page 1: ...High Speed Positioning System HSPS UPH Series ...
Page 2: ...en Operation Manual ...
Page 80: ......
Page 81: ......
