Figure 5.5: Tie Threads used to Group and Secure Cables
Wiring the Video Cable
Note: The terminals support AWG 20 (0.5 mm
2
) to AWG 28 (0.08 mm
2
) cables.
To wire the video cable, follow these steps:
1.
Locate the coaxial termination cable that is in the Cable and Screws accessory bag.
2.
Use a small screwdriver to press down on the GND push latch (see the figure) and attach
the black ground wire to the GND terminal.
3.
Use a small screwdriver to press down on the VIDEO push latch (see group 101) and
attach the clear coaxial conductor to the VIDEO terminal.
4.
Retract the shield covering the female BNC connector and route the coaxial termination
cable into the base of the device.
5.
Route the incoming coaxial cable with a male BNC connector into the base and connect
to the female BNC connector on the coaxial termination cable.
6.
Move the shield to cover the coaxial connection.
5.3
High-Speed Positioning System
(HSPS)
Installing the High Speed Positioning System | en
25
Bosch Security Systems, Inc.
Operation Manual
2013.11 | 5.2 | F.01U.291.981
Summary of Contents for UPH Series
Page 1: ...High Speed Positioning System HSPS UPH Series ...
Page 2: ...en Operation Manual ...
Page 80: ......
Page 81: ......