Bosch UPH Series, Operation Manual

Page: 22 / 82

2. Insert the cables into the optional wall or pole mount so that they protrude approximately
0.5 m (19.7 in.).
1
2
(19.7 in.)
0.53 m
(19.7 in.)
0.53 m
MTC-WUPH
MTC-PUPH
Figure 5.2: Optional Wall Mount (1) or Pole Mount (2)
!
Warning!
The cables should not be accessible by unauthorized personnel; cables should be secured to
fixed locations at appropriate intervals to bare the weight of the cables, for example, cables
running inside a tall camera pole.
!
Warning!
Be sure to use appropriately strong and load-bearing bolts and other fixing materials when
installing any UPH mountings to any surface.
3. Attach the optional wall or pole mount according to the specific mounting manual.
Part Description
MTC-PUPH Outdoor Pole Mount for UPH Series
MTC-WUPH Outdoor Wall Mount for UPH Series
MTC-POLE-W Pole Adapter for MTC-WUPH
MTC-CORN-W Corner Adapter for MTC-WUPH
Installing the optional washer kit
Notice!
If using a washer kit (optional, sold separately), you must install the support for the washer
pipe before positioning and wiring the pan/tilt. Refer to the Installation Manual for the Washer
Kit.
Installing the HSPS base on the mount
1.
Remove the desiccant bag from inside the base and discard.
2. Remove the cable glands from the base and fit the gasket / seal ring.
3. Insert the cables into the cable glands while holding the base approximately 20 cm from
the bracket. Note that there are three glands; one for power, one for video, and one for
data / IO cables.
22 en | Installing the High Speed Positioning System
High-Speed Positioning System
(HSPS)
2013.11 | 5.2 | F.01U.291.981 Operation Manual Bosch Security Systems, Inc.