Bosch PRAESENSA PRA-AD604, Configuration Manual, Page: 113 / 164

PRAESENSA Security | en 113
Bosch Security Systems B.V. Configuration manual 2020-09 | V1.20 | PRAESENSA 1.20
7.1 System security
1. Below the Security page, click System security:
– A new screen OMNEO system security appears where the:
– OMNEO security username, and the
– OMNEO passphrase can be viewed. These are both automatically created at 1
st
time /
initial
Logon the application, page 35.
2. Both credentials are used to create a secure connection between the PRAESENSA
system controller, the other network devices, PC and during upgrade of the PRAESENSA
network devices firmware.
3. See Change user name and passphrase, page 113 if you want to change the credentials.
4. See 1
st
time / initial
Logon the application, page 35 for the automatically generated
secured credentials.
5. See Check/Upload the devices firmware, page 20 for a secured device firmware upload
connection.
6. See Backup and restore, page 103 for a (secured) backup and restore of your
configuration file.
7.1.1 Change user name and passphrase
The security user name and passphrase are automatically generated and created at 1
st
time /
initial logon. See Logon the application, page 35, if required.
To change:
1. Below the System security page, click the + of the Change user name and passprase
category row:
–
Make sure that all configured network devices are connected. See also Show
disconnected devices, page 114.
2. Click the Generate (recommended) button which will generate a new User name and
Passphrase or enter a new User name (minimum 5 and maximum 32 characters) and
Passphrase (minimum 8 and maximum 64 characters):
– IMPORTANT : for security reasons, both the User name and Passphrase need to be
changed.
3. Click the Change button:
–
IMPORTANT : Devices that get disconnected during the change process will still
receive the changes upon reconnection within one hour . After one hour, remaining
devices must first be reset to factory default, and then reconnected. See Reconnect
factory default devices, page 113.
Refer to
– User accounts, page 38
7.1.2 Reconnect factory default devices
Use this function if you want to securely reconnect one or more factory default devices. Notice
that reconnect a network device only works when it was already added in
System
composition, page 40.
To do so:
1. Reset the disconnected device(s) to default by using the reset to default button:
–
For location of the reset to default button of the individual devices, see Device
options, page 43 > <device name> > Rear panel indicators and controls and/or the
PRAESENSA installation manual.