Bosch PRAESENSA PRA-AD604, Configuration Manual, Page: 102 / 164

102 en | Configure the system PRAESENSA
2020-09 | V1.20 | PRAESENSA 1.20 Configuration manual Bosch Security Systems B.V.
5.9 Save configuration
Most of the pages in the Configure section of the webserver contains a Submit button. Always
click this button after making changes, otherwise the changes are lost. Click the Submit
button, however, does not mean that the changes are saved. Therefore, you always have to
save the configuration on the system controller.
To do so:
1.
Click the Save configuration page button:
– A (limited) confidence check on the configuration is executed automatically. When
your computer is connected to the system (controller), and there are no issues
found, the configuration is correctly done, and the following three buttons and one
checkbox are displayed to enable you to:
1 - Save configuration (button)
2 - Restart system (button)
3 - Save configuration and restart system (button)
Clear event logging on restart (checkbox)
2. When there are issues found, a message is displayed indicating there are configuration
issues to be resolved first. Still it is possible to ignore the errors and save the
configuration anyway to continue the configuration at a later time.
–
Only one button is displayed: Ignore errors and save configuration.
3. Click the Ignore errors and save configuration button:
– The errors will be ignored and the configuration will be saved.
1 - Save configuration
By clicking the Save configuration button, and no issues (errors) are found, the configuration
file is saved on the system controller. To reload and activate the saved configuration, restart
the system controller.
2 - Restart system
Click the Restart system button to restart the system (controller) without saving the current
configuration. In this case the existing, and already saved, configuration file will be reloaded.
Notice that possible changes in the current configuration will be overwritten at reloading.
3 - Save configuration and restart system
By clicking the Save configuration and restart system button, and no issues (errors) are found,
the configuration file is saved on the system controller, and the system (controller) will be
restarted and reloading, plus activating, the just saved configuration.
Clear event logging on restart
By enabling (checkmark) the Clear event logging on restart checkbox, all events logged on the
system controller will be erased after the system has been restarted.
–
Note that the events are still visible in the Logging Viewer. See
Optional: Using the
Logging Viewer, page 125.
Refer to
– Logon the application, page 35
– Backup and restore, page 103