PRAESENSA
Configure the system | en
41
Bosch Security Systems B.V.
Configuration manual
2020-09 | V1.20 | PRAESENSA 1.20
5.2.2
Add a device
With the exception of the initial added network device (system controller), no other
connected network devices are listed on the system composition page after using the
rediscover function. This means that you have to add and set each network device to the
system composition first. Only then the network device could be recognized, listed and
configured in the system. See
Logon the application, page 35, if required.
To do so:
1.
Click
the Add button:
–
An Adding row appears.
2.
Enter
the device Name in the text box:
–
The name may consist of up to 32 characters.
3.
Select
the Device type from the dropdown list:
–
The Device type name (e.g. PRA-AD608 is part of the Amplifier category) is fixed and
cannot be changed by the user.
4.
Click
the Add button below the row, or
click
the Cancel button to return:
–
By using the Add button, the device, including the unique Device hostname, will be
added to the System composition.
–
When Add a System client device, you will be asked to
enter
the IP‑address.
5.
Select
an
unused
device hostname from the Host name dropdown list:
–
The device hostname consists of an extraction of the commercial type number name
and the last 6‑digits of the MAC‑address. The device hostname is fixed and cannot be
changed by the user. Refer to the label on the device. See
–
When you
select
an already used device hostname, a prompted message will ask you
to
select
another (unused) one, as soon you
click
the Submit button.
–
When you
select
unknown no device (type) will be linked because the correct
hostname is not selected.
–
If not already done, select the device hostname of the initially added network device
(system controller) from the Host name dropdown list.
6.
Optional enter
the Location (free text) name in the text box:
–
This could be e.g. the name of the physical location of the network device.
7.
Click
the Submit button:
–
Notice that the changes are not permanent until the configuration is saved. See
8.
Only
after Save configuration and restart system, the function of Show identification
checkbox can be activated.
Enable
(checkmark/on) the checkbox or
disable
(off) the
Show identification checkbox if you (not) want to visualize identification of the
selected
network device:
–
By enabling
, the LEDs of the network device front/top (and rear) panel will be
immediately switching intermittent on and off as long Show identification is enabled.
–
Disable
the checkbox to stop the network device (LED) identification.
Notice!
If an added device is disconnected from the PRAESENSA network afterwards, the Hostname
will be colored "light grey" only after using the Rediscover function and upon entering the
web page. Besides that a lost device fault event messages is generated.
Summary of Contents for PRAESENSA PRA-AD604
Page 1: ...PRAESENSA Public Address and Voice Alarm System en Configuration manual ...
Page 2: ......
Page 163: ......