Bosch DSA E Series, Installation Manual

Page: 45 / 150

E2600 DSA E-Series iSCSI Disk Arrays Installing the Drive Trays for the E2600 Controller-Drive Tray Configurations | en 45
Bosch Security Systems Installation Manual - | V2 | 2012.09
This procedure describes how to install the mounting rails into an industry standard cabinet.
1. Make sure that the cabinet is in the final location. Make sure that you meet the clearance
requirements shown in the following two figures.
Note:
Fans pull air through the tray from front to back across the drives.
Figure 7.1 DE1600 Drive Tray Airflow and Clearance Requirements
2. Lower the feet on the cabinet to keep the cabinet from moving.
3. Remove the drive tray and all contents from the shipping carton.
4. Position the mounting rails in the cabinet.
Note:
– If you are installing the mounting rails above an existing tray, position the mounting
rails directly above the tray.
– If you are installing the mounting rails below an existing tray, allow 8.8-cm (3.5-in.)
vertical clearance for the drive tray.
CAUTION!
Possible hardware damage
To prevent electrostatic discharge damage to the tray, use proper antistatic protection when
handling tray components.
1 76 cm (30 in.) clearance in front of the cabinet
2 61 cm (24 in.) clearance behind the cabinet