Bosch DSA E Series, Installation Manual

Page: 29 / 150

E2600 DSA E-Series iSCSI Disk Arrays Installing and Configuring the Switches | en 29
Bosch Security Systems Installation Manual - | V2 | 2012.09
3.2 Procedure – Installing and Configuring Switches
1. Install your switch according to the vendor’s documentation.
2. Use the Compatibility Matrix at the website
http://www.lsi.com/
compatibilitymatrix/
to obtain this information:
– The latest hardware compatibility information
– The models of the switches that are supported
– The firmware requirements and the software requirements for the switches
3. Update the switch’s firmware by accessing it from the applicable switch vendor’s
website.
This update might require that you cycle power to the switch.
4. Find your switch in the following table to see whether you need to make further
configuration changes. Use your switch’s configuration utility to make the changes.
Table 3.2 Supported Switch Vendors and Required Configuration Changes
Switch Vendor Configuration Changes
Required?
Next Step
Brocade Yes
Change the In-Order Delivery
(IOD) option to ON.
Make the change, and go to
Section 4 Installing the Host Bus Adapters
for the E2600 Controller-Drive Tray,
page 30
Cisco Yes
Change the In-Order Delivery
(IOD) option to ON.
Make the change, and go to
Section 4 Installing the Host Bus Adapters
for the E2600 Controller-Drive Tray,
page 30
LSI No See Section 4 Installing the Host Bus
Adapters for the E2600 Controller-Drive
Tray, page 30
McData No See Section 4 Installing the Host Bus
Adapters for the E2600 Controller-Drive
Tray, page 30
QLogic No See Section 4 Installing the Host Bus
Adapters for the E2600 Controller-Drive
Tray, page 30
PowerConnect No See Section 4 Installing the Host Bus
Adapters for the E2600 Controller-Drive
Tray, page 30