Bosch DSA E Series, Installation Manual

Page: 103 / 150

E2600 DSA E-Series iSCSI Disk Arrays Replacing a Controller Battery in the Controller-Drive Tray | en 103
Bosch Security Systems Installation Manual - | V2 | 2012.09
Figure 14.7 Controller LEDs
24. On both controller canisters, look at the Link Service Action Required LEDs and the
Controller Service Action Required LEDs. Based on the LED status, perform one of these
actions:
– For each controller, the Host Link Service Action Required LEDs are on and the
Controller Service Action Required LED is off
Go to step 26.
– On one controller, the Host Link Service Action Required LEDs are off, or the
Controller Service Action Required LED is on
Check that the controller canister has been installed correctly. Reinstall the control-
ler canister if necessary. Go to step 25.
25. Did this action correct the problem?
– Yes
Go to step 26.
– No
If the problem is not resolved, contact your Customer and Technical Support repre-
sentative.
26. Complete any remaining Recovery Guru procedures, if necessary.
27. Using the LEDs and the storage management software, check the status of all of the trays
in the storage array.
28. Does any component have a Needs Attention status?
– Yes
Click the Recovery Guru toolbar button in the Array Management Window, and com-
plete the recovery procedure. If the problem is not resolved, contact your Customer
and Technical Support representative.
– No
Go to step 29.
29. Remove the antistatic protection.
30. Create, save, and print a new storage array profile.
1 Host Link 1 Service Action Required LED
2 Host Link 2 Service Action Required LED
3 Battery Service Action Required LED
4 Controller Service Action Allowed LED
5 Controller Service Action Required LED