Bosch DSA E Series, Installation Manual

Page: 33 / 150

E2600 DSA E-Series iSCSI Disk Arrays Installing the E2600 Controller-Drive Tray | en 33
Bosch Security Systems Installation Manual - | V2 | 2012.09
Figure 5.2 Airflow Direction Through and Clearance Requirements for the E2600 Controller-Drive Tray with
24 Drives
1. Make sure that the cabinet is in the final location. Make sure that the cabinet installation
site meets the clearance requirements (see Figure 5.1, Page 32 and Figure 5.2, Page 33 ).
2. Lower the feet on the cabinet, if required, to keep it from moving.
3. Install the mounting rails in the cabinet. For more information, refer to the installation
instructions that are included with your mounting rails.
– If you are installing the mounting rails above an existing tray, position the mounting
rails directly above the existing tray.
– If you are installing the mounting rails below an existing tray, allow 17.8-cm (7.00-
in.) clearance below the existing tray.
1 76-cm (30-in.) clearance in front of the cabinet
2 61-cm (24-in.) clearance behind the cabinet
WARNING!
Risk of bodily injury
Two persons are required to safely lift the component.
NOTICE!
Risk of equipment malfunction
To avoid exceeding the functional and environmental limits, install only drives that have been
provided or approved by the original manufacturer. Not all controller-drive trays are shipped
with pre-populated drives. System integrators, resellers, system administrators, or users of
the controller-drive tray can install the drives.