Bosch DSA E Series, Installation Manual

Page: 129 / 150

E2600 DSA E-Series iSCSI Disk Arrays Replacing a Controller Canister and Related Components | en 129
Bosch Security Systems Installation Manual - | V2 | 2012.09
6. Look at the LEDs on the controller canister to make sure that the controller is booting
correctly.
The LEDs come on and go off intermittently for approximately 60 seconds (possibly
longer). After this time, you are able to discover the controller canister by using the
storage management software.
7. Look at all of the controller-drive tray’s Service Action Required LEDs. Based on the LED
status, perform one of these actions:
– All of the Service Action Required LEDs are off, and the Array Management
Window indicates an Optimal status
Go to step 9.
– Any of the controller-drive tray’s Service Action Required LEDs is on
Check that the controller canister has been installed correctly. Reinstall the control-
ler canister if necessary. Go to step 8.
Note:
If your storage array does not have an Optimal status, click the Recovery Guru toolbar
button in the Array Management Window to determine if any other actions are required.
8. Did this action correct the problem?
– Yes
Go to step 9.
– No
If the problem is not resolved, contact your Customer and Technical Support repre-
sentative.
9. Complete any remaining Recovery Guru procedures, if needed.
10. Using the LEDs and the storage management software, check the status of all of the trays
in the storage array.
11. Does any component have a Needs Attention status?
– Yes
Click the Recovery Guru toolbar button in the Array Management Window, and com-
plete the recovery procedure. If the problem is not resolved, contact your Customer
and Technical Support representative.
– No
Go to step 12.
12. Remove the antistatic protection.
13. Create, save, and print a new storage array profile.