Bosch AutoDome 600 Series, User Manual

Page: 63 / 74

AutoDome 600 Series Analog PTZ Camera User Command Table | en 63
Bosch Security Systems, Inc. User Manual F.01U.270.005 | 2.0 | 2012.06
On/Off 100 Record A Activate/Deactivate
On/Off 101 Record B Activate/Deactivate
On 997 FastAddress, display Display current address
On 998 FastAddress, all units Display and program current address
On 999 FastAddress, unaddressed domes Display and program unaddressed AutoDomes
Set “1-99” Pre-position Programming Set ##–Programs a preset view
Shot “1-99” Pre-position Recall Shot ##–Recall programmed preset
Set 100 Pre-position Menu Enters the Pre-position menu
Set/Shot 101 Autopan Left Limit Set–Programs left limit
Shot–Shows limit
Set/Shot 102 Autopan Right Limit Set–Programs right limit
Shot–Shows limit
Set 110 Factory P/T Home Position Set–Recalibrate home position
On/Off 680 Homing Recalibration Display Displays the current mode of operation, intervals,
time until the next calibration, and the number of
recalibrations that have occurred.
On – Turns display on.
Off – Turns off the display.
On/Off 681 Homing Recalibration On – Enables recalibration (This action does not
cause the dome to re-home immediately)
Off – Disables recalibration
On 682 Recalibration Mode Each On command toggles the recalibration mode
as follows:
– Recalibrates only on the loss of home position.
– Recalibrates on the loss of home and for every
periodic interval.
On/Off 683 Recalibration Interval Changes the homing recalibration interval. Intervals
are in 6-hour increments up to 72 hours.
Each On – increases interval by 6 hours
Each Off – decreases interval by 6 hours
On/Off 684 Initial Offset Time Sets the initial offset time for the recalibration
interval. The offset time starts after the Homing
Calibration is enabled. The recalibration interval
begins its countdown after the offset time.
Each On – increases offset time by 4 hours
Each Off – decreases offset time by 4 hours
Note: The offset time does not take effect until the
Homing Calibration is enabled.
On 911 Remote Restart Simulates a power cycle. Once issued the
AutoDome re-homes and displays the start-up
splash screen.
Set 900 Edit Tour 1 (Standard) Enters the Standard Tour Scene menu
Shot 900 Edit Tour 2 (Custom) Enters the Custom Tour Scene menu
Set/Shot 901-999 Adds/Removes a Preposition Shot from
Tour 1
Set ###–Adds preset
Shot ###–Removes preset
Function
Key
Comm
No.
Command Description