Bosch AutoDome 600 Series, User Manual

Page: 42 / 74

42 en | Keyboard Commands by Number AutoDome 600 Series Analog PTZ Camera
F.01U.270.005 | 2.0 | 2012.06 User Manual Bosch Security Systems, Inc.
On/Off 95 Display Azimuth/Elevation
Readings
On–Displays azimuth/elevation readings
Off–Hides azimuth/elevation readings
Refer to Section 7.8 Azimuth, Elevation, and
Compass Directions, page 52 .
On/Off 96 Display Compass Readings On–Displays compass heading
Off–Hides compass heading
Refer to Section 7.8 Azimuth, Elevation, and
Compass Directions, page 52 .
On 99 Factory P/T Home Position Recalibrates home position; can be used as an
Alarm Output
On/Off 100 Record A Activate/Deactivate
On/Off 101 Record B Activate/Deactivate
On 997 FastAddress, display Display current address
On 998 FastAddress, all units Display and program current address
On 999 FastAddress, unaddressed domes Display and program unaddressed AutoDomes
Set “1-99” Pre-position Programming Set ##–Programs a preset view
Shot “1-99” Pre-position Recall Shot ##–Recall programmed preset
Set 100 Pre-position Menu Enters the Pre-position menu
Set/Shot 101 Autopan Left Limit Set–Programs left limit
Shot–Shows limit
Set/Shot 102 Autopan Right Limit Set–Programs right limit
Shot–Shows limit
Set 110 Factory P/T Home Position Set–Recalibrate home position
On/Off 680 Homing Recalibration Display Displays the current mode of operation,
intervals, time until the next calibration, and the
number of recalibrations that have occurred.
On – Turns display on.
Off – Turns off the display.
On/Off 681 Homing Recalibration On – Enables recalibration (This action does not
cause the dome to re-home immediately)
Off – Disables recalibration
On 682 Recalibration Mode Each On command toggles the recalibration
mode as follows:
– Recalibrates only on the loss of home
position.
– Recalibrates on the loss of home and for
every periodic interval.
On/Off 683 Recalibration Interval Changes the homing recalibration interval.
Intervals are in 6-hour increments up to 72
hours.
Each On – increases interval by 6 hours
Each Off – decreases interval by 6 hours
Locked Function
Key
Comm
No.
Command Description