AutoDome 600 Series Analog PTZ Camera
Getting Started | en
5
Bosch Security Systems, Inc.
User Manual
F.01U.270.005 | 2.0 | 2012.06
1
Getting Started
Install and wire the AutoDome according to the
VG5 AutoDome Installation Manual
. A typical
system includes a keyboard, matrix switcher, monitor, and appropriate wiring connections.
Please refer to the individual product manuals for complete installation and setup instructions
for each of the system components.
1.1
Powering On
When you turn the AutoDome power on there is a ten (10) second pause before the dome
starts its homing phase. During the homing phase the camera pans left and right and tilts up
and down. It also adjusts the lens focus. The entire homing phase lasts approximately 40
seconds and ends with a firmware version screen.
Figure 1.1
Sample VG5 Startup Firmware Version Screen
The splash screen displays the type of AutoDome, the camera installed, the firmware levels for
various files, and the current IP address (for VG5 AutoDome 700 Series models).
1.2
Establishing AutoDome Control
The most common ways to interface with the AutoDome are:
–
Using a keyboard and on-screen display (OSD) menus. This method is the most common
and is covered in this manual.
–
Using the AutoDome Configuration Tool software running on a PC with Bilinx or the RS-
232/485 communication protocol. Refer to the
CTFID User Manual
for instructions.
–
Using a PC-based graphical user interface (GUI) such as the Bosch DiBos 8 software.
Refer to the DiBos 8 User Guide for instructions.
Bosch Security Sys. AutoDome(r)
600 Series
Day/Night 36X
SC Boot
FPGA
VCA_boot
STD Comm
No Heater
FastAddress: Not Set
5.00.00.03/1.05.00.02
1.00.00.00
5.00.00.03
1.13.01.05
1.02.00.01
Summary of Contents for AutoDome 600 Series
Page 1: ...AutoDome 600 Series Analog PTZ Cam era VG5 600 Series en User Manual ...
Page 2: ......
Page 73: ......
