AutoDome 600 Series Analog PTZ Camera
Alternative Control Protocols | en
33
Bosch Security Systems, Inc.
User Manual
F.01U.270.005 | 2.0 | 2012.06
8.
Move the joystick down then back up to set the
FastAddress
number.
9.
Press the
FOCUS
or the
IRIS
button to store the
FastAddress
number.
The on-screen display menu confirms that the VG4 AutoDome stored the FastAddress
number.
4.2
Pelco Protocol Mode
The Pelco Mode features Auto Baud Detection that automatically detects and adjusts the
AutoDome protocol and baud rate to match that of the controller. The AutoDome responds to
Pelco-D or Pelco-P protocol commands.
4.2.1
Hardware Configuration
The AutoDome is configured from the factory for RS-485 operation in
Pelco Protocol Mode
.
1.
Connect the controller's TX terminals to the AutoDome's TxD terminals. See the
AutoDome Modular Camera System Installation Manual
for complete wiring instructions.
2.
Pan or tilt the keyboard joystick to confirm that control has been established to the
AutoDome (approximately five (5) seconds).
Figure 4.1
RS-232/RS-485 Selection Switch
NOTICE!
The AutoDome supports only the RS-485 protocol while in Pelco mode. It does not transmit
responses back to the controller.
NOTICE!
If control is not established, ensure that the RS-232/RS-485 selector switch is positioned to
RS-485 (outward toward the LED lights). This switch is located on the bottom of the
AutoDome CPU board, under the camera head and next to the LED lights. See Figure 4.1.
1
CPU Module
2
Switch Location
3
LEDs
4
RS485
Summary of Contents for AutoDome 600 Series
Page 1: ...AutoDome 600 Series Analog PTZ Cam era VG5 600 Series en User Manual ...
Page 2: ......
Page 73: ......
