Access Easy Controller
How to Install the Access Easy Controller | en
23
Bosch Security Systems
Hardware Manual
Ver 2.0.0 | 2006.07
5
How to Install the Access Easy Controller
5.1
Preliminary
1.
You will need to obtain the following information from the customer before the controller
can be installed.
a.
Mounting location for controller and lock/strike power supplies. The selected loca-
tion should be secure and offer protection from accidental damage. It should also
provide reasonable temperature and humidity conditions, and should be free from
sources of electrical and electromagnetic interference.
b.
110 VAC power source for UL Listed system or 230 VAC power source for Non UL
Listed system. The power source should be protected against accidental shutoff.
c.
Network connection point - either a wall jack or an available hub where a category-5
cable can be plugged in, to provide the Access Easy Controller with access to the
customer's network.
2.
The customer will also need to provide you with some additional information before the
controller can be made operational.
a.
An IP address for the controller
b.
The subnet mask to be used by the controller.
c.
If a gateway is used by the customer's network, then obtain the gateway address to
be used by the controller.
d.
E-mail server IP address, port number, and domain name (only needed if the cus-
tomer intends to use the controller's e-mail notification services).
e.
Location of an analog telephone line (only needed if a dial-in connection will be
used).
3.
For a UL-compliant installation, adhere to the following installation guidelines:
a.
The controller must be installed in the same room as the network jack or hub.
i
NOTICE!
If the Access Easy Controller is going to be directly connected to a host computer on its own
private network, and not be connection to the customer's company network, then the control-
ler's default IP address setting (129.2.0.41) can be used.
