BOREAL LASER GasFinderMC-2, Operation Manual

Page: 10 / 90

2.2
Boreal Laser Inc. GasFinderMC Operation Manual— Pre-Installation July 17th 2017
Duct Probes
Alignment is made easier if the fl anges for the Duct Probes are
welded perpendicular to the path axis. Clean air up to 10 litres/
min, controlled with a regulator, should be provided for purging
the Duct Probe and retro windows. Ducts with a heavy dust load,
may require a higher fl ow rate.
Tools
Required:
Site-specifi c personal protective equipment •
Permanent marker or pen •
Set of assorted cable ties •
Nylon spiral wrap •
Socket wrench set •
Small adjustable “crescent” wrench •
Small vise grips •
Small fi le •
Phillips, Robertson and Flat Head screwdrivers •
Allen Keys (imperial and metric) •
Coaxial-cable termination tool •
(Amphenol crimper: ARF1118 with CTL-3 jaws. 0.100D and 0.429D.)
Wire cutters, wire stripper, linesman’s scissors, pliers •
Knife •
Duct tape •
Electrical tape and self-amalgamating tape •
Label maker or cable markers •
Silicone sealant RTV3145 •
Twist drill set and step-bit or hole-saw selection •
Small multimeter •
Diagnostic and Troubleshooting Kit •
Ladder and/or man-lift (as appropriate) •
If pre-terminated cables are not used then a cable splicer is required capable of making •
FC/APC connections.
Optional/Recommended:
Tap set •
Portable drill •
Bungee cords (assorted sizes) •
Two-way radios (if permitted) •
Equipment Check
Verify that all the equipment on the order sheet has
arrived complete and in good condition. Any damage
due to shipping should be reported immediately and
steps taken to obtain replacement parts.
Order ready for shipment
2 Duct Probes with Purge
Air and Splice Box