Integrated Multi-parameter Sensor Operation manual
29
5.1.2 Sensor connection (choose one of two ways of connection between sensor
connection and Bluetooth connection)
1
）
Press the key of direction to choose “setting”, and press the key of “Enter” to get in. And then, press
the key of direction again to choose “controller set”. Press the key of “Enter” to get in, and choose
“sensor”. After the process of getting in, depend on the situation to decide “power output” options.(That
is to say, provide the power supply for the integrated multi-parameter analyzer by hand manipulator. )
Note: to be sure that the integrated multi-parameter analyzer is starting up in the process of
operation by hand manipulator. Please check the details in Chapter 3.2.
2
）
Press the key of direction to set the baud rate of probe. Press the keys of up and down to choose baud
rate of “19200”, and then choose “scanning”. At last, press the key of “Enter” to confirm.
3
）
Settings of manual and automatic refresh of data. Choose the key of “0” in the options of “refresh rate”,
and press the key of “OK” to confirm. Then the manual operation mode is set when the constant data is
displayed. Choose the keys of other numbers, and press the key of “OK” to confirm. Then the automatic
operation mode is set when the constant data is displayed. For instance, when you choose the key of “5”,
then the constant data will be refreshed once every 5 seconds. (the key of “1” and “2” cannot be chose as
their rates of refreshing are too fast. )
4
）
Withdraw from setting of the sensor connection by pressing the key of “Esc”.
5.1.3 Sensor connection
1
）
Press the key of direction to choose the key of “setting”, and press the key of “Enter” to get in. The
process is showed by the diagram as below. (It can be displayed only when the probe and hand
manipulator are connected.)