Integrated Multi-parameter Sensor Operation manual
23
and finally click to open.
Tip: If the sensor has been connected as described, and the software prompt has not been connected,
remove and replace the USB port or check the USB to RS485 converter, repeat the above operation until
the sensor connection is successful.
4.2.1 Online data
When online data measurement, first click on "Online Data" and then set the save path, refresh settings,
tag name, etc. as shown. Then click the mode setting at the top right of the software to select "Online
Data", click "Confirm" to monitor the online data in real time. If you select "Automatically switch"
directly, you do not need to re-select the operating mode when changing the menu bar.
The "starting time", "total number" and "temperature source" of the meter can be viewed in the
information board, as shown in the figure below.
4.2.2 Calibration
Calibration module will be specified in the following (Chapter 6 Sensor Calibration) and will not be
described in detail here. First select the operation mode in the upper right corner as “Calibration”, then
click “Confirm”, and select the parameter to be calibrated from the calibration menu to calibrate. If you
select “Automatically switch” directly, you do not need to re-select the operation when changing the