43
Troubleshooting
3. If you are unsure of the settings of the peripheral card, remove all cards
except the SE1440 and other essential cards (i.e., video display adapter,
hard disk controller) from your system. Run “CSACDIA1” (see section
5.1) each time you remove an interface card. If your SE1440 functions
properly after removing an interface card from your system, the
interface card you just removed is in conflict with your SE1440. Find out
the DMA channel, IRQ, and I/O port address which the interface card is
using. Change the settings on your SE1440 or the interface card so that
the two are not using the same values.
IMPORTANT! It is advisable to change the jumper settings on the
other interface card since some Sound Blaster games use the
default Sound Blaster settings (i.e., 1/0 Port Address = 220H,
Interrupt = 5, DMA = 1). These games might not work properly if
you change the settings for the SE1440.
For commonly encountered problems, continue to the next page.
Summary of Contents for SoundExpression 14.4VSP
