13
Installing Your New SE1440
2.3 Installing the SoundExpression 14.4
1. Make sure you exit Windows. Then, before physically installing the
SoundExpression 14.4 in your computer, run COMCHECK to determine
which serial port address is available in your system. Insert the diskette
labeled “SE1440 Driver and Utility diskette 1 of 1” and type:
A:COMCHECK
or
B:COMCHECK
.
2. Read all on-screen instructions and select the option, “I have not yet
installed the SE1440
.”
3. Next, you are asked if you have a CD-ROM drive
a. If no, select “No, I do not have a CD-ROM drive” and continue
with step 4.
b. If yes, select “Yes I have a CD-ROM drive” you are asked if you are
using the SE1440 as the adapter card for the CD-ROM drive.
1. If you reply “No”, continue with step 4.
2. If you reply “Yes”, you are asked for the type of CD-ROM
interface you will be using (“IDE interface” or “Any other
type...
”); respond to this question and continue with step 4.
4. Follow the on-screen instructions. Write the recommended COM and
IRQ settings here:
COM____ IRQ____
5. Remove the SE1440 from its anti-static bag, handling it by its edges and
retaining bracket. Be careful not to touch the edge connector or any
components on the card. Locate the blue or black plastic jumpers as
described on the following page.
Make sure the jumper settings you just wrote down in step 4 match the jumpers
on the SE1440. If not, change them now.
Summary of Contents for SoundExpression 14.4VSP
