Boca SoundExpression 14.4VSP, User Manual

Page: 83 / 96

83
Appendix K: Compliance Information
FCC Statement:
This device complies with part 15 of the FCC rules. Operation is subject to the following two
conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference received including interference that may cause
undesired operation.
THIS UNIT COMPLIES WITH FCC PART 68 AS OF DATE OF MANUFACTURE.
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of FCC rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses, and
can radiate radio frequency energy and, if not installed in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
• Re-orient or relocate the receiving antennae.
• Increase the separation between the equipment and the receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
• Consult the dealer or an experienced radio/TV technician for help.
Note: This unit was tested with shielded cables on the peripheral devices. Shielded cables must
be used with the unit to insure compliance.
Note: The manufacturer is not responsible for any radio or TV interference caused by
unauthorized modifications to this equipment. Such modifications could void the user’s
authority to operate the equipment.
Notification to the Telephone Company
Notification to the telephone company is no longer required prior to connecting the registered
equipment but upon request from the telephone company the user shall tell the telephone company
which line the equipment is connected to as well as the registration number and the ringer equivalence
of the registered protective circuitry. In most, but not all areas, the sum of all RENs should be 5.0 or less.
The FCC Registration number and Ringer Equivalence number are printed on the main chip in the
center of the internal modem board.
Compliance Information