Boca SoundExpression 14.4VSP, User Manual

Page: 15 / 96

15
Installing Your New SE1440
7. Connect the ribbon interface cable from the CD-ROM drive to the
appropriate interface connector on the SE1440 before inserting the
board into your computer. The connectors are labeled Sony, Mitsumi,
IDE and Panasonic. Note: If your CD-ROM is not listed, consult your
CD-ROM documentation to determine which type of connector it
emulates. If your CD-ROM drive is any type IDE, use the IDE
connector, regardless of the manufacturer. For example, for a Mitsumi
IDE CD-ROM drive, use the IDE connector.
8. If an audio cable is included with your CD-ROM drive, connect it from
the CD-ROM drive to the respective CD-ROM sound input connector
labeled Sony/IDE, Panasonic, and Mitsumi. For an IDE CD-ROM, use
the Sony/IDE connector. Note: If your CD-ROM manufacturer is not
listed, refer to your CD-ROM documentation to determine which
sound input connector to use.
colored stripe
12345678901
12345678901
12345678901
12345678901
12345678901
12345678901
12345678901
12345678901
12345678901
12345678901
12345678901
12345678901
12345678901
12345678901
12345678901
12345678901
12345678901
12345678901
12345678901
12345678901
12345678901
12345678901
1234567890
1234567890
1234567890
1234567890
1234567890
1234567890
1234567890
1234567890
1234567890
1234567890
1234567890
1234567890
1234567890123456
1234567890123456
1234567890123456
1234567890123456
1234567890123456
1234567890123456
1234567890123456
1234567890123456
1234567890123456
○ ○ ○
○ ○ ○
○
○
○
○
○
○
○
○
○
○
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
ð
CD-ROM audio cable
CD-ROM drive
(rear view)
pin
1
SPK
L-
O
UT
L-IN
MIC
CAUTION: When connecting cables,
be sure that Pin 1 on the cable,
usually marked with a colored stripe
(often red), matches up with pin 1 on
the board connector. A band on the
connector outline denotes Pin 1.
NOTE: Some CD-ROM drives
have jumpers for a “MASTER/
SLAVE” configuration. In that
case, make sure the CD-ROM
drive is set for “MASTER”.
A white block and “#1” indicate Pin 1