Blue Bird Coachworks 450 LXi, Owner'S Manual

Page: 100 / 684

450 LXi Owner Manual 4-5 Leveling Systems
~ 4-5-3 ~
Rev. “C”
SUSPENSION
AIR PRESSURE
Parked Mode Buttons and Indicators
Level Indicator Light “Y” or
Long Axis
Y-LEVEL - DONE
Solid Green
- RV is near level
Y-LEVEL - NORMAL RANGE
Flashing Green
- Adjustment is possible
and within range.
Y-LEVEL - MARGINAL RANGE
Flashing Amber
- Marginal conditions
- possible self-level.
Y-LEVEL - OUT-OF-RANGE
Solid Amber
- Excessive slope - Self-leveling
may not be possible.
Level Indicator Light “X” or Short Axis
X-LEVEL - DONE
Solid Green
- RV is near level.
X-LEVEL - NORMAL RANGE
Flashing Green
- Adjustment is possible and
within range.
X-LEVEL - MARGINAL RANGE
Flashing Amber
- Marginal conditions
- possible self level.
X-LEVEL - OUT-OF-RANGE
Solid Amber
- Excessive slope - Self-leveling
may not be possible.
SELF LEVEL - ACTIVATION
Press once to activate the “Self-Leveling”
process.
SELF LEVEL - STANDBY
Press once again to switch the self-leveling to
“standby”. This will cancel leveling and maintain
current position.
SELF LEVEL - RE-ACTIVATE
Press again to re-activate “Self-Leveling” process.
See Parking Brake Note.
LEVEL - IN PROCESS
Indicator fl ashes as system levels
the motorhome.
LEVEL - DONE
The indicator stays “on” after
leveling is done.
AIR LEVEL - ON
Press once to activate the SLS System
and initiate the “Level Find Mode”
AIR LEVEL - OFF
Press once again to turn the SLS off
and return to normal height.
NOTE: This function may be used at
low speeds to locate a level parking
surface.
SLS Control Functions and Indicators
4-5.2.2 Power ON
When the vehicle is fi rst turned on, the Hadley SAMS will gather information from the sensors. This period of time will be
approximately 5 seconds. The system will not make any adjustments during this time. See the troubleshooting section if the
Suspension Light stays on or starts blinking.
Note: The “Level Find Mode” is used to help locate a level surface on which to park before the SLS “SET”
button is used.
Note: The parking brake must be applied before the SLS “SET” feature can be used.