211
[6 MONITORING CONFIG.]
Name/Description
•
[6.1 PARAM. BAR SELECT]
-
[Alarm groups]
-
[Frequency ref.]
-
[Output frequency]
-
[Motor current]
-
[Motor speed]
-
[Motor voltage]
-
[Motor power]
-
[Motor torque]
-
[Mains voltage]
-
[Motor thermal state]
-
[Drv. thermal state]
-
[DBR thermal state]
-
[Input Power]
-
[Consumption]
-
[Run time]
-
[Power on time]
-
[IGBT alarm counter]
-
[PID reference]
-
[PID feedback]
-
[PID error]
-
[PID Output]
-
[- - - - 2]
to
-
[- - - - 6]
-
[Config. active]
-
[Utilised param. set]
-
[Local / Remote]
in Hz: parameter displayed in factory configuration
in Hz
in A
in rpm
in V
in W
as a %
in V
as a %
as a %
as a %
in W or kW depending on drive rating
in Wh or kWh depending on drive rating
in hours (length of time the motor has been switched on)
in hours (length of time the drive has been switched on)
in seconds (total time of IGBT overheating alarms)
as a %
as a %
as a %
in Hz
Word generated by the Controller Inside card (can be accessed if the card has been inserted)
Word generated by the Controller Inside card (can be accessed if the card has been inserted)
CNFO, 1 or 2 (see page
164
)
SET1, 2 or 3 (see page
162
)
Display factory configuration. “LOC” appears if the command and reference are set via the graphic
display terminal; otherwise, “REM” appears. This corresponds to the state selected by the
[T/K]
function key, page
113
.
Select the parameter using ENT (a
then appears next to the parameter). Parameter(s) can also be deselected using ENT.
1 or 2 parameters can be selected.
Example:
PARAM. BAR SELECT
MONITORING
- - - - - - - - -
- - - - - - - - -
- - - - - - - - -
- - - - - - - - -
Summary of Contents for ER40-G
Page 2: ......
Page 21: ...21 The display flashes to indicate the presence of a fault ...
Page 241: ......
