Blaze King TORINO, Users Installation Operation & Maintenance Manual

Page: 36 / 48

The torino
Page 36
Conversion Kit Contents
This conversion kit contains the following parts:
1) Z0755P (LPG)> # 59 orifice for the right orifice, # 53 orifice for the left and LPG Stepper motor kit
2) Z0755 (NG)> # 52 orifice for right orifice, # 39 orifice for left and NG Stepper motor kit
3) Conversion Kit labels
To convert from NG to LPG or reverse, follow the next steps .
- Replace orifices, see page 38 for Burner tray removal &installation.
- Replace stepper motor (see next page).
- Convert pilot fuel (see instructions below)
How to convert Pilot fuel:
Use a 7/16” wrench to loosen the pilot hood
Push the little tab in and the little tab with hole should pop out.
The hole stamp tab (LP) out is used for Propane
The stamped tab (NA) out is for Natural Gas
Re-tighten the pilot hood.
Fill out the fuel conversion label on the appliance (inside side doors)
See page 9 for proper pilot and burner flame pictorials.
All valves have been pre-set and certified for installation at elevations from 0 – 4500 feet (1 – 1372m)
above sea level.
High Elevations
When installing this unit at higher elevations, it is necessary to decrease the input rating by replacing
the existing burner orifice with a smaller size for installations over 2000 feet (608 m). The appliances
input should be reduced 4% for each additional 1000 feet (305 m) above sea level. For the USA, de-
rate the unit from sea level according to the gas installation code.
Altitude Natural Gas
Orifice Size
Right Left Right Left
0 – 4,500 ft (0 – 1372 m) 52 39 59 53
4,500 – 6,500 ft (1372 – 1981 m) 53 40 60 54
6,500 – 8,000 ft (1981 – 2438 m) 54 41 61 55
Propane
Orifice Size
FUEL CONVERSION
“WARNING”
This conversion kit shall be installed by a qualified service agency in accordance with
the manufacturer’s instructions and all applicable codes and requirements of the
authority having jurisdiction. If the information in these instructions is not followed
exactly, a fire, explosion or production of carbon monoxide may result causing property
damage, personal injury or loss of life. The qualified service agency is responsible for
the proper installation of this kit. The installation is not proper and complete until the
operation of the converted appliance is checked as specified in the manufacturer’s
instructions supplied with the kit.