4.10.1 GVRP C
ONFIG
Table 4-29. GVRP Configuration screen options.
Parameter Description
GVRP Config
In the function of GVRP Config, it is used to configure each port’s
GVRP operation mode, in which there are seven parameters
needed to be configured described below.
GVRP State Setting
This function is simply to let you enable or disable GVRP function.
You can pull down the list and click the
Downward
arrow key to
choose
Enable
or
Disable
. Then, click the
Apply
button, the
system will take effect immediately.
Join Time
Used to declare the Join Time in unit of centisecond. Valid time
range: 20 –100 centisecond, Default: 20 centisecond.
Leave Time
Used to declare the Leave Time in unit of centisecond. Valid time
range: 60 –300 centisecond, Default: 60 centisecond.
Leave All Time
A time period for announcement that all registered device is going
to be de-registered. If someone still issues a new join, then a
registration will be kept in the switch. Valid range: 1000-5000 unit
time, Default: 1000 unit time.
Default Applicant Mode
The mode here means the type of participant. There are two
modes, normal participant and non-participant, provided for the
user’s choice.
Normal: It is Normal Participant. In this mode, the switch
participates normally in GARP protocol exchanges. The default
setting is Normal.
Non-Participant: It is Non-Participant. In this mode, the switch does
not send or reply any GARP messages. It just listens messages
and reacts for the received GVRP BPDU.
24-Port 10/100BASE-TX L2 Managed PoE Switch with 2 SFP Dual Media Ports
62
