Bioer GeneQ Thermal Cycler, Manual, Page: 4 / 33

Gene Q Thermal Cycler Important Note
―III―
HANGZHOU BIOER TECHNOLOGY CO., LTD.
Name: GeneQ Thermal Cycler
Model
：
TC-**/H(b)
Power: 100-120V ～ 50/60Hz 200W
Fuse: 125V 5A(Φ5×20) Sort: class
Ⅰ
IP20
SN: BYQ*****-***
Date: ****.** Made in China
b) Warning Sign
Warning! There are two warning signs read ‘HOT SURFACE !’. The metal part near those
signs (on the block and hotlid) is not allowed to be touched by any part of the
body for fear of the body burn, during the program execution and in the short
period after the program execution!
6 MAINTENANCE
The conical holes over the block should be cleaned regularly with soaked cotton swab. That
ensures sufficient contact and thus good heat conduction between each conical hole and the tube
inside it.
In case it is smeared, the surface of the Thermal Cycler may be scrubbed with a piece of
dehydrated soft wet cloth.
7 WARRANTY AND SERVICE INFORMATION
a) Warranty
The Thermal Cycler is warranted for a period of one month, from date of shipment from the
company, to be free from defects in material and workmanship. The Bioer Co. shall be obligated,
under this warranty, to exchange the Thermal Cycler which proves to be defective as described
herein.
The Thermal Cycler is also warranted for a period of eighteen months, from date of shipment from
the company, to be free from defects in material and workmanship. The Bioer Co.’s obligation under
this warranty shall be limited to repair or exchange (at the Bioer Co.’s option) of the Thermal Cycler
Warning! During surface cleaning, the power must be off.
Corrosive scour is not allowed to clean the surface.