Gene Q Thermal Cycler
Chapter 5 Upgrade of Software
—
18
—
2
To Modify, Repair or Remove the Upgraded Software
1)
If there is an Gene Q Thermal Cycler installation procedure in your computer, click “setup.exe”
to start the guide to modify, repair or remove software (refer to the following picture). You can
select “Modify”, “Repair” or “Remove”, and then press “Next” to achieve corresponding
operation.
2)
Click “Modify” and press “Next” to edit installation subassembly, press “Finish ” to finish this
step (refer to the following picture).
Note:
It is necessary to select “Installation file”. If you delete “√” before “installation file”, it will
cause incomplete software installation procedure in your operating system.
3)
Click “Repair” and press “Next” to repair installation procedure. Press “Finish” to end this step.
Note:
The shortage of “all files” can’t be repaired, but you can repair it by choosing “modify” function
and then add “all files”.
4)
Click “Remove” and press “Next” to delete installation procedure. Press “Finish” to end this
step.
Summary of Contents for GeneQ Thermal Cycler
Page 33: ...NOTES...